The Micro 9 cycles well and ejects without any problems or jams. I know Kimber customer service has been able to fix this problem before for customers, and if it's just by giving them a longer firing pin, I may try and get them to send me a new one. All Kimber Micro 9 Holsters come standard with: Made with Black. After that shot is fired, on the next trigger pull the piece of. When this happens, a small chunk of the primer simultaneously blows back into the hole where the firing pin sits. I have seen a post where a guy makes a new firing pin that is longer, so that when the firing pin goes back into its hole, it is staying close enough to the primer to the point where that chunk of the primer can't get blown back, because it is supported by the firing pin tip. For background: some micro 9s (not just mine) will fire, and after the firing pin goes back into its hole, the gases blow out through the indent made by the firing pin. After that shot is fired, on the next trigger pull the piece of the primer that came off comes forward with the firing pin and gets sandwiched between the firing pin and the next cartridge's primer, and it doesn't fire. For those of you that have had the issue with Micros blowing out the primer, have you found any easy solutions without making new parts or sending it back?įor background: some micro 9s (not just mine) will fire, and after the firing pin goes back into its hole, the gases blow out through the indent made by the firing pin.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |